Roland HP 2700 - Page 4

How to assemble the KS-3700 Roland piano stand
© You will need a coin to tighten the screws.
© Assembly will be easier if done by two people.
<Check the parts>
© Before you begin assembly, check that you have all the parts.
@® Side board (left) 0...
Side board (right) ... :
© Pedal board .............
@ Center board ....
©® Side covers ........ is
@) Rear board oo... eee
enw oo
@ Short screws (M4 x 40 mm) ..
@ Long screws (M6 x 60 mm) ...
@ Connecting screws
@) Philips screwdriver ae
@ Joint nuts eee
G@® eno
~y
<Assembly procedure>
l Attach the side boards (left and right) to the pedal board.
% Extend the pedal cable out from the pedal board.
The finished surface
is on the inside.
@ Attach the pedal cable
using the clamps on the left
side board. @
Note: Cable clamp
Note that the side
boards have screws for
attaching the rear
board.
@ Use the long screws
(M6 x 60 mm) to
attach the side boards
to the pedal board
{use two screws for
each side).
The finished surfaces
2 Attach the center board should face wards
@ Insert the four joint nuts into the center board
with the long groove horizontal, making sure
that the holes of the joint nuts are aligned with
the holes of the center board.
Insert a short screw before attaching the side
boards to check that the holes of the joint nuts
and the center board are positioned correctly.
@ Use the short screws
(M4 x 30 mm) to
attach the center board
to the side boards (use
two screws for each
side).