Roland HP 38006 - Page 7

INTRODUCTION
Insert the plug on the power cord into an outlet.
Press the POWER button at the left side of the panel to turn power ON.
After a few seconds the display shown below appears.
Push to turn
Press again for
OFF
Note, though, that depending on the setting in effect for the COMPUTER switch (page 36, 37) on the
rear panel, you could see one of the screens shown below. Should that be the case, you might not be
able to use the Piano Partner (refer to page 14), or MIDI data arriving at MIDI IN could be ignored.
Should the above appear in the display, refer to page 36, 37.
* Due to its circuitry protection feature, this instrument requires a few seconds immediately after
power up before it is ready for operation.
* Make sure to always use only the power cord that was supplied with this unit.
* Always be sure to use a power source that provides the amount of voltage this unit is designed for.
* Whenever you do not intend to use the unit for an extended period of time, pull the power cord’s
plug out of the outlet.
A headphone jack is located at the front left side of the instrument. Once you have headphones connected, the unit’s
speakers will no longer produce sound. By listening through headphones. you can play whenever you please (such as
late at night) without worrying about bothering others.
The VOLUME slider on the instrument is used to adjust the headphone volume.
We recommend that you use stereo headphones. preferably the optionally available Roland RH-
20/80/120.