Roland HP 730 - Page 10

English
INTRODUCTION
0
Alternate Button Functions
Each button also offers another function if you hold down the Transpose button while
you press it. These alternate functions are explained below.
After
the
desired
value
for
one
of
these
functions
has
been
set
using
the
[+/-]
buttons,
press
the
Transpose
button
(the
indicator
goes
out).
This
causes
the
new
setting
to
be
activated.
: ° Harps Vibta Bleciie“Eleciic
Plana 1° Piano 2° Sibi «pone «Panes bam ge suis
ter] - Classical)’ Srached= [Pedal] {doa |. [Tx eh
Tuning [4 Tuning {4 Mode | 2 Batanc
©
Riven
alla ‘Sat the value with { « /~j buttons
1, Piano 1 Button (Master Tuning)
Allows you to adjust the tuning. (p. 30)
2. Piano 2 Button (Classical Tuning
Allows you to set the tuning method. (p. 28,29)
3. Harpsichord Button (Stretch Tuning}
Allows you to set the tuning curve. (p. 31)
4. Vibraphone Button (Pedal Mode)
Allows you to select Pedal modes. (p. 34)
5. Electric Piano 1 Button (Dual Balance)
Allows
you
to
adjust
the
volume
balance
for
Dual
playing.
(p.32
)
6. Electric Piano 2 Button (Tx ch)
Allows you to set the MIDI transmit channel. (p. 36)
7. Pipe Organ Button (Rx ch)
Allows you to set the MIDI receive channel. (p. 37)
8. Strings Button {Local Switch)
Allows you to select Local On or Off.(p. 37)
9. Chorus Button (Transmit Mode)
Allows you to select the MIDI transmit mode. (p. 38)
10. Receive Button (PC)
Used
to
enable
transmission
/reception
of
Program
Change
messages.
(p.
38)
About the [+/-] Buttons
Basically,
any
of
the
[+/-]
buttons
can
be
used
to
select
values
for
most
of
the
parameters.
However,
the
beat
can
be
set
only
with
the
Beat
[+/-]
buttons,
the
Tempo
can
be
set
only
with
the
Tempo
[+/-]
buttons,
and
Demo
Song
settings
can
be
altered
only
with
the
Song
[+/-|
buttons.