Roland JD-XA - Effects; Effects Edit; MFX Edit; Cc01-Cc31

17
Eects
To move MFX, PART EQ, TFX1, TFX2, REVERB, or DELAY, hold down the [Shift] button and use the cursor [
K
][
J
] buttons.
Eects Edit
1. Press the [Menu] button.
2. Use the cursor [
K
] [
J
] buttons to select “EFFECTS EDIT” and press the [Enter] button.
MFX: Switch parameter appears.
Eect type
[Shift] + Cursor [
K
] [
J
]
Parameter storage location
MFX PART (TONE)
PART EQ PAR T
TFX1/TFX2 PROGRAM
REVERB PROGRAM
DELAY PROGRAM
MFX Edit
Menu
[Shift] + Cursor [
K
] [
J
]
Parameter
Cursor [
K
] [
J
]
Value
Value [-] [+]
Explanation
MFX
(MFX)
Switch
(MFX Switch)
OFF, ON Species whether multi-eect will be used (ON) or not used (OFF).
Use this parameter to select from among the 67 available MFXs. For details on multi-eects parameters, refer to “MFX Parameters” (p. 25).
MFX CTRL
(MFX Control)
Src1
(Source 1)
Src2
(Source 2)
Src3
(Source 3)
Src4
(Source 4)
Sets the MIDI message used to change the multi-eects parameter with the MFX Control.
OFF Multi-eects control will not be used.
CC01–CC31
CC33–CC95
Controller number 1–31, 33–95
BEND Pitch bend
AFT Aftertouch
SYS1, SYS2, SYS3, SYS4 MIDI messages used as common multi-eects controls.
Dest1
(Destination 1)
Dest2
(Destination 2)
Dest3
(Destination 3)
Dest4
(Destination 4)
Refer to the parameters marked “#” on “MFX Parameters” (p. 25) and following.
Sens1, Sens2, Sens3,
Sens4
-63–0–+63
Species the depth of MFX Control. To make an increase in the currently selected value (to get
higher values, move to the right, increase rates, and so on), select a positive value; to make a
decrease in the currently selected value (to get lower values, move to the left, decrease rates,
and so on), select a negative value. For either positive or negative settings, greater absolute
values will allow greater amounts of change. Set this to “0” if you don’t want to apply the eect.