Roland JD-XA - JD-XA Data Management and Reset; Restoring Backup Data from USB; Factory Reset and Auto Off Settings

19
Eects
TFX Parameters
Parameters that are aected by Limit Mode are indicated by a symbol.
Parameter Value Explanation
01: Flt+Drive
(FILTER+DRIVE)
A low-pass lter with overdrive. It cuts the high frequencies and adds distortion.
Cuto 0–127 Adjusts the frequency that will be cut.
Resonance
0–127 Adjusts peak frequency response at the cuto frequency.
Drive
0–127 Adds distortion.
02: Isolator
(ISOLATOR)
Isolates or removes the low, mid, or high frequency ranges.
Low
0–127 Isolates/removes the low-frequency range.
Mid
0–127 Isolates/removes the mid-frequency range.
High
0–127 Isolates/removes the high-frequency range.
03: DJFX Looper
(DJFX LOOPER)
Loops a short portion of the input sound. You can vary the playback direction and playback speed of the input sound to add turntable-type eects.
Length
0–127 Species the length of the loop.
Speed -1.0–+1.0
Species the playback direction and playback speed.
Negative (-) settings make the sound play backward. Positive (+) settings make the sound play forward. With a value of
0.0, playback stops.
Loop Sw OFF, ON If you turn this on while sound is playing, the sound at that point will be looped. Turn this o to cancel the loop.
04: BPM Looper
(BPM LOOPER)
Loops a short portion of the input sound.
Length
0–127 Species the length of the loop.
Timing OFF, 1–8
Species the timing (in 8th note units) at which sounds looped during a measure will automatically start playing. If you
don’t want the loop to play automatically, turn this “OFF.”
Loop Sw OFF, ON If you turn this on while sound is playing, the sound at that point will be looped. Turn this o to defeat looping.
05: Bit Crush
(BIT CRUSH)
This creates a lo- sound.
Sample Rate 0–127 Adjusts the sample rate.
Bit
0–127 Adjusts the bit depth.
Filter 0–127 Adjusts the lter depth.
06: Wah
(WAH)
Produces a wah eect.
Peak 0–127 Adjusts the width of frequencies to which eect is applied.
Rate 0–127 Adjust the speed of modulation.
Manual 0–127 Adjusts the pitch of the eect sound.
07: Reverb
(REVERB)
Adds reverberation to the sound.
Reverb Time 0–127 Adjusts the reverberation time.
Tone 0–127 Adjusts the tone of the reverberation.
Balance D64–63E Adjusts the volume balance between the direct sound and eect sound.
08: Delay
(DELAY)
Repeats the sound.
Delay Time Note *1 Adjusts the interval of the repeats.
Feedback
0–127 Adjusts the number of the repeats.
Balance D64–63E Adjusts the volume balance between the direct sound and eect sound.
09: Tape Echo
(TAPE ECHO)
Simulates a tape-type echo unit of the past.
Rate 0–127 Species the tape speed.
Intensity 0–127 Species the amount of echo repeat.
Balance D64–63E Adjusts the volume balance between the direct sound and eect sound.