Roland JP-8080 - Performance Parameters

● Standard Settings
When PERFORM: TEMPORARY is executed, the Upper/Lower Patch parameters and Performance parameters will be
set as follows.
When PATCH: TEMPORARY is executed, Patch parameters will be set as follows.
◆ Performance parameters
* The Voice Modulator parameters ([VOICE MOD] (BANK [2]) and Voice Modulator panel parameters) are the same as when
Voice Modulator Initialize is executed to “F.FLT: VINTAGE.”
◆ Performance parameters (Voice Modulator panel)
Performance Name INIT PERFORMANCE
Part Detune 0
Output Assign MIX OUT
Voice Assign
Split Point
Arpeggio Dest
(4) 5-5 (4)
C 4
LOWER&UPPER
Arp Beat Pattern 1/16
Indv Trig Switch OFF
Indv Trig Dest FILTER
Indv Trig Src CH 15
IndvTrigSrc Note ALL
[
PFM COMMON
] (
BANK
[
1
] )
Algorithm
Control1 Assign VOCAL MIX
Control2 Assign
ENSEMBLE LEVEL
Ext->Inst Send
Ext->Vocal Send
V Delay Type
ON
ON
V Delay Sync OFF
Ensemble Type
ENSEMBLE MILD
Ensemble Sync OFF
Vocal Morph Ctrl OFF
Vocal Morph Sens +32
[
VOICE MOD
] (
BANK
[
2
] )
Vocal Morph Thrsh 10
SOLID
PANNING L->R
Part Transpose
Part MIDI CH 2
Chorus Sync OFF
Delay Sync
LFO Sync
[
PART
] (
BANK
[
3
] )
0 0
1
OFF
OFF OFF
OFF OFF
LU
EXT
142