Synth Kick Drum
158
1 Use the Initialize operation to set the performance
to the standard settings.
[INIT/UTIL]: Initialze: PERF: TEMPORARY
2 In the OSC COMMON section, set OSC BALANCE
to the far right position.
Only the OSC2 sound will be used.
3 In the OSC2 section, set [RANGE] and [FINE/WIDE]
to the far left position.
This will produce an ultra-low sound.
4 In the PITCH ENVELOPE section, set [DEPTH] and
[D] to the positions shown in the diagram.
This will produce a synth drum-like sound.
5 In the FILTER section, set [CUTOFF FREQ] to the
position shown in the diagram.
6 In the FILTER ENVELOPE section, set [DEPTH]
and [D] to the positions shown in the diagram.
7 In the AMP section, set [LEVEL] to the maximum
position.
8 In the AMP ENVELOPE section, set [D][S][R] to the
positions shown in the diagram.
9 Set TONE CONTROL [TREBLE] to the position
shown in the diagram.
10
Set the Patch Gain to “+6dB.”
[PATCH]: Patch Gain: +6dB
* Be careful not to damage your speakers, etc.
11
In the FILTER section, move [CUTOFF FREQ] and
notice how the tonal character of the kick is affect-
ed.
12
In the FILTER ENVELOPE section, increase
[DEPTH] to add an attack.
13
Increase TONE CONTROL [BASS] as desired to
apply a low boost.
* Avoid increasing this excessively, since this may dam-
age your speakers, etc.
To Next Page
Loading...
