Quick Start
23
Playing the Sounds
The JP-8080 contains a wide variety of sounds. In this section we will select Performances to hear the vari-
ous sounds. The Performances are organized into the following groups.
USER: Sounds which can be rewritten
PRESET1–3: Sounds which cannot be rewritten
CARD01–64: Sounds saved on an optional memory card
* P2: 83–P2: 86 are performances which use the formant filter. These should be played while inputting
vocals through the MIC jack. This is especially true in the case of P2:84 and P2:86—they will not sound at
all unless vocals are being input. (p.103)
* P2: 87 is a performance which uses the external input. There will be no sound unless sound is being input
to the EXT IN jack. (p.26, 70)
* CARD sounds can be selected only if a memory card is inserted into the CARD slot. (p.128)
Performances are selected by specifying the three items Group (USER/PRESET1–3/CARD01–64), Bank
(1–8), and Number (1–8). For this example, let’s select performance “P1: 24 1979!”
1 Make sure that the upper left of the display indicates “PERFORM.”
If not, press [PERFORM/PATCH SELECT] to get the correct display.
2 Use GROUP [DOWN]/[UP] to select a Group (P1: Preset1).
3 Press BANK [2] to select a Bank (2).
The BANK [2] indicator will light.
4 Press NUMBER [4] to select a Number (4).
The NUMBER [4] indicator will light.
The Performance has now been selected.
Play the connected MIDI keyboard and listen to the sound of the selected performance.
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
◆ For more details on Performances
➜ “Patches and Performances” (p.55)
◆ For details on Performance numbers and the contents of each
➜ “Performance List” (p.176)
To Next Page
Loading...
