Modifying the Volume
The parameters of the AMP (Amplifier) section and the
AMP ENVELOPE (Amplifier Envelope) section modify the
volume, and how the sound begins and ends.
AMP (Amplifier) Section
[LEVEL]
Specify the volume of the Patch. The volume will increase
as the knob is rotated toward the right.
The [LEVEL] setting is saved in the Patch, so if you want
each Patch to have a different volume, you can set each
Patch accordingly. In contrast, the VOLUME [LEVEL] is
used to adjust the volume of the entire JP-8080.
[PAN] (Auto Pan/Manual Pan Switch)
Select one of three ways in which the volume or pan (stereo
position) will change.
OFF (dark):
LFO 1 (p.77) will cyclically modulate the volume.
AUTO (Auto Pan):
LFO 1 will cyclically shift the panning between left and
right.
MANUAL (Manual Pan):
Adjust [LFO1 DEPTH] to pan the sound to left or right.
* The LFO 1 Fade Time setting has no effect on Auto Pan.
* In the following cases, the Auto Pan and Manual Pan
effects will be unavailable.
• When the sound is being sent from the output jacks in
MONO.
• When Output Assign (p.115) is set to PARALLEL OUT.
[LFO 1 DEPTH]
When [PAN] is OFF (dark) or set to AUTO, this parameter
determines how greatly LFO 1 (p.77) will be applied to
Level or Pan. Rotating the knob toward the right of center
will produce greater change. Rotating the knob toward the
left of center will invert the LFO 1 waveform, and produce
greater change in the opposite direction. With a central set-
ting, LFO 1 will not affect level or pan.
When [PAN] is set to MANUAL, rotating the knob toward
the right of center will pan the sound toward the right, and
rotating it toward the left of center will pan the sound
toward the left. With a central setting, the sound will be
heard from the center.
◆ When [PAN] is OFF (dark) or set to AUTO
◆ When [PAN] is set to MANUAL
AMP ENVELOPE
(Amplifier Envelope) Section
[A] (Attack Time) / [D] (Decay Time)
[S] (Sustain Level) / [R] (Release Time)
These parameters set the Attack Time, Decay Time, Sustain
Level, and Release Time of the amplifier envelope. Raising a
slider will increase the corresponding value.
To Next Page
Loading...
