Canceling the Settings of a
Parameter
If you wish to cancel the settings only for a specific parame-
ter of the parameters being controlled, use the following
procedure to set the width of change to 0 for that parameter.
1 Move the slider/knob to the lowest (far left) posi-
tion for the parameter whose settings you wish to
cancel.
2 Press MORPHING [CONTROL ASSIGN].
The indicator will blink, and the control assign page will
appear.
3 Slightly raise (or rotate to the right) the slider/knob,
and then return it to the lowest (far left) position.
4 Press [CONTROL ASSIGN] or [EXIT].
The indicator will light (or go dark if all parameters
were canceled), and the previous display will reappear.
The parameter settings have now been canceled.
5 Move the slider/knob to the desired position.
* You can also use the Control Edit Scope (p.64) to set the
width of parameter change to zero.
Canceling the Settings of
All Parameters
1 Press MORPHING [CONTROL ASSIGN].
The indicator will blink, and the control assign page will
appear.
2 Press [WRITE].
The display will indicate “Completed.”
All parameter settings have now been canceled.
Also, the Morph Bend Assign Switch will be turned
OFF.
3 Press [CONTROL ASSIGN] or [EXIT].
The indicator will go dark, and the previous display will
reappear.
Control Using MIDI Messages Other Than
Aftertouch and Breath (Control Up/Down)
You can make settings in order to control using MIDI mes-
sages other than aftertouch and breath (MODULATION:
CC01–CC31, CC33–PHASER: CC95, AFTERTOUCH). If this
is turned OFF, control assign settings will have no effect
even when the controllers of your external MIDI device are
operated.
Control Up/Down settings are common to the entire JP-
8080.
1 Press [EDIT].
The [EDIT] indicator will light and the BANK [1]–[8]
indicators will blink.
2 Press [MIDI] (BANK [5]) several times to access the
Control Up or Control Down display.
The [MIDI] indicator will light.
3 Use [DEC]/[INC] to set the value.
4 When you finish making settings, press [EDIT] or
[EXIT].
The previous display will reappear.
The Control Up/Down settings have now been made.
86
To Next Page
Loading...
