99
Moving Sliders or Knobs
While Playing Back Motions
You can also move sliders or knobs to add further tonal
changes while a Motion is playing back.
If you move a slider/knob whose movement was recorded
in the Motion, the movement of the slider/knob will take
priority, and the Motion-controlled tonal change will switch
to the change being controlled by the slider/knob. If you
then stop moving the slider/knob, the tone will again
change according to the Motion when the Motion returns to
the beginning.
If you move a slider/knob whose movement was not
recorded in the Motion, the sound will change in the way
that it normally does.
ā Switching between Motions and Slider/Knob
Movements
The sliders/knobs of the JP-8080 have 11 switch points.
When a slider/knob is moved past one of these switch
points, control over the parameter change will be trans-
ferred from the Motion to the slider/knob movement.
Playing Back a Motion From the Beginning
Each Time a Key is Pressed (Motion Restart)
This setting lets you specify whether a Motion will be
played back from the beginning each time a key is pressed.
Motion Restart is common to the entire JP-8080.
OFF: The Motion will continue playing back even if you
press a key again.
ON: If a key is pressed after all keys are released, the
Motion will be played back from the beginning.
* This means that when you record a Motion while play-
ing back a Pattern, the Pattern and Motion will begin
playback simultaneously when you press the key of the
Pattern if Motion Restart is turned On. This is a conve-
nient way to ensure that the start timing of the Pattern
and Motion are aligned.
1 Press [EDIT].
The [EDIT] indicator will light and the BANK [1]ā[8]
indicators will blink.
2 Press [SETUP] (BANK [6]) several times to access
the Motion Restart display.
The [SETUP] indicator will light.
3 Use [DEC]/[INC] to set the value.
4 When you finish making settings, press [EDIT] or
[EXIT].
The previous display will reappear.
The Motion Restart setting has now been made.
Switching Motion Sets
The JP-8080 has two Motion Sets (SET A/SET B), with two
motions in each set. Also, up to four sets (CARD1: SET
A/SET B, CARD2: SET A/SET B) can be saved in a memory
card. (p.131)
These Motion Sets can be easily switched and used.
Motion Sets are common to the entire JP-8080.
1 Make sure that a memory card is inserted in the
card slot.
* If the card is not inserted, turn the power off, and insert
the card with the side without contacts (gold colored)
facing upward.
2 Hold down [SHIFT] and press MOTION [USER]
(NUMBER [3]), [CARD 1] (NUMBER [4]) or [CARD 2]
(NUMBER [5]).
USER: Internal motion sets
CARD 1: Memory card motion sets
CARD 2: Memory card motion sets
3 Hold down [SHIFT] and press MOTION [SET A]
(NUMBER [7]) or [SET B] (NUMBER [8]).
While you hold down [SHIFT], the indicator of the but-
ton that you pressed will light.
The Motion Set has now been changed.
* If no motions have been saved on the memory card, it
will not be possible to select [CARD 1]/[CARD 2]
motions.
To Next Page
Loading...
