This copy function allows
the user to copy
any
patch program and
arrange the program
numbers. There may be
some patch
prog-
rams
which are more often used
than others.
If these patches are
collected in the
same
bank, it will be easier to
decide where to write
a
new patch, which after
alt save
a
great deal
of work and
time.
*
This function is particularly
useful when the
Patch Shift Function
(Refer
to 24)
is being
used.
Operation
(T) Set the Memory Protect
Switch on the rear
panel to OFF.
{§)
Assign the patch
program to be copied by
pressing the Bank Group
Selector Button
first, then the Bank
Number
and
Patch
Number Buttons.
(The Bank and the Patch Numbers are
shown in the
Display.)
(3)
If you are to copy the
patch into the same
Bank, press the
relevant Bank Number and
Patch Number Buttons,
while holding the
Write Button. To copy the
patch program
into
another Bank Group, it is
required to
assign the Bank Group. Hold the
Write But-
ton down and
press the Bank Group
Selec-
tor Button before pressing the
Bank
Number and Patch
Number Buttons.
•
The Bank and
the Patch numbers are
shown in the Display
Window, and writing
is completed.
(4)
Set the Memory
Protect Switch to ON.
> Example
Copying a
patch
from A-18
to B-23
GROUP A-(
group
e'l
(Either of the
Buttons can
be
pressed first.
ilaai£Mfl
I
u
I
u
Recall A-18
WRITE
While holding the
Write Button down
U
i I
SELECT
GROUP A
GROUP
8 ? 8
(
Either of the Buttons
can be pressed
first.
J
/
MEMORV
PROTECT
ON OFF ON
To Next Page
Loading...
