*
Operation
(J)
Set
the
tape
recorder
to
recording mode.
(2)
Make sure
the appropriate Bank
Group
In-
dicator is lighted (if Group
A, the red
one,
and if Group B, the green one). If not, press
the
Bank
Group
Selector
Button
and
change it.
(3)
Press the Save Button.
•
The Save Indicator lights up
and
the indi-
cation in the Dispaiy
Window
goes out
(Here, Pilot tone
is
ouput through the
Save
Jack).
©
If your tape recorder features a
recording
level control,
set the
ievel
so
that the Pilot
tone will
read
around
VU.
®
In about 4 to 5
seconds, the Pilot tone will
turn to Modulated tone, and
saving will
start. (Please be sure to adjust the level
while the Pilot tone is still heard.)
*
Press the Manual Button to stop saving in
the
middle.
*
If
the
Save
Indicator goes out and the
Dis-
play shows
"
—
",
saving
is
completed.
*
Every data will be automatically saved
twice just in case.
(|)
Stop
the
tape
recorder.
*
It may be a good idea to
verify
every one
of the data you have
saved.
Make sure if
connection
is completed
REC PLAY
R£C
SELECT
GROUP A
0\
GflOUP B
CH~
SAVE
-4-
/
'
\
ovu
STOP
SAVE
O
STOP
To Next Page
Loading...
