Roland JUNO-106 - Verify

Operation
(?)
Set the tape so that the beginning of the
data wiii
start
(where you hear Pilot tone).
*
If your tape recorder features
a
playback
level control, set it to medium volume.
Make sure if
connection
is completed
Setting the
tape
(2)
Assign the
Bank Group A or B
you wish to
verify,
by
pressing the Bank Group Selec-
tor Button.
(|)
Set the tape recorder to playback mode,
then press
the Verify
Button.
®
The Verify
indicator will light up and Bank
Patch Number Display will go dark. Then
verify will begin.
*
If the
Verify Indicator
goes out
and the dis-
play shows
Manual indication
"
- -
",
ver-
ify is completed.
*
Press the
Manual
Button to stop verifying
in
the
middle.
(4)
Stop the tape
recorder.
*
if there is any
error,
"
t
r
"
will be indi-
cated in the Display Window. If so, care-
fully repeat verify procedures. Aiso, try
changing the volume and tone color of the
tape
recorder.
*
ff
error is indicated again and again,
refer
to
P.15.
/
?
\
SELECT
GROUP A
0\
GROUP B
CA-
(Tape
Recorder)
PLAY
L .
l t
STOP
O