(j)
Set the tape so that
the data starts from
the beginning {where you hear pilot tone).
(5)
Set the Protect Switch on
the
rear panel to
OFF.
(3)
Select
either Bank Group A or B where you
are to load the data, by
pressing the Bank
Group Selector Button.
(T) Set the tape
recorder to playback mode
and press
the Load Button.
*
The Load
Indicator lights
up and the indi-
cation in the Display
Window will
go out.
And loading wilt start.
*
Be sure to
press
the
Load Button before
the
Pilot
tone turns to Modulated tone.
*
Press
the
Manual
Button to stop
loading
in
the
middle.
(D
If loading is completed,
set
the Memory
Protect Swich to ON, and stop
the
tape
re-
corder.
*
If
error
is indicated, carefully repeat
Load
procedure.
*
If
error is indicated again and again, refer
to P.5.
In the Juno-106, a whole Bank
Group
is
saved,
verified and loaded. It is possible to load the
Bank Group A data saved on a tape into the
Bank Group B in memory. The reverse way is
also possible (Bank
Group B-Bank Group A).
sure if connection
is completed
Setting
the tape
MEMGRV
PROTECT
ON OFF ON
r
SELECT
GROUP A
(
GROUP
B(
{Tape Recorder)
PLAY
u
I f
L
/ f
STOP
O
{Tape Recorder)
STOP
MEMORY
PROTECT
ON
OFF ON
To Next Page
Loading...
