If error is indicated in Verify
or Load proce-
dure of Tape Interface,
carefully repeat
each
procedure taking care
of the following points.
Press
the Verify or Load key before the
data
you are
to
verify
or load starts.
Please do
not start
recording
from the very
head of the tape,
but
after
slightly winding
it.
Make
sure that connections are
made prop-
erly.
Tape you use
Use a new and high quality
tape, if possi-
ble. An old tape is liable
to have drop-out,
therefore likeiy
to cause error more often.
Use a cassette tape shorter
than C-60. The
one longer
than C-90 is too thin for proper
operation.
Try using the
same tape recorder in Saving
and Loading,
so
that
possibility of error will
be reduced.
If
your tape recorder has two kinds of
In/
Out Jacks (i.e. MIC/LINE in, EAR/LINE
Out,
etc), try using different ones this
time.
Some tape recorders do not allow proper
operation when both Save and
Load con-
nections
are made at the same
time. In
such a case, make only the relevant
con-
nection.
• Clean
and demagnetize the head of
the
tape recorder.
*
If error is still indicated,
use a different
tape
recorder.
Preserving
Data
Tape
Please
do not keep the
data recorded tape
in extreme heat or
humidity or near
strongly magnetic
units such as speaker or
an amplifier.
Also, be sure that the tape is
completely rewinded.
To Next Page
Loading...
