The variation
of each knob.
Attack Time
•
Setting of ADSR
and Envelope
Curve.
Time (sec)
Decay Time and Reiease
Time
Time
{sec)
Sustain Level
Voltage
In the figure shown above,
the
positions of
the knob are not meant
to
be exactly
correct,
so
the knob
position does not nece-
ssarily
correspond with the time and the
voltage.
**
When all of the
ADSR
sliders
are set to
zero, the waveform
will be an extremely
short Pulse wave,
and only a short "click"
is heard.
Please be
careful.
(Low Frequency
Oscillator)
This oscillator generates
only low frequency
signal. It controls
the
DCO and the VCF to pro-
duce
vibrato
and growl effects.
This sets the rate of the LFO.
©
DELAY TIME Knob
This sets the time needed for the LFO to
start to function.
DELAY
RATE TIME
© ©
(3)
Bender Lever
While
this lever is being
pushed back, vibrato
effect by
LFO
is
obtained.
@
LFO Modulation Depth Knob
This determins the depth of the LFO Modula-
tion.
*
Refer to P. 23 for the details of the Bender
Lever and LFO Modulation Depth Knob.
To Next Page
Loading...
