1
.
GeHing
Ready
to
Play
Connecting
with Audio
Equipment
The
JV-iasn has no
built-in amp
or speakers, so
in
order to produce
sound
you'll
have to use
a key-
board amp or audio
system, or at
least a pair
of
headphones.
Refer to the
following
comiection
diagram.
*
No
connection
cables (such as the
P]-1M)
are
included ivith
this product.
Tliese cables
must be
acquired
separately.
^3^
Before
making
any
connections, make sure
that all the
devices
are turned
off. This
will help
prevent
damage or
malfunction.
^^
Connect
the included AC
cord to the
inlet
on the
back of the
unit, and
plug the
other
end
into
an
electrical outlet.
^^^
Hook up
the audio
cables as
shown
beloW. If you're
going to use
headphones,
plug
them
into the
PHONES
jack on the
front
panel.
JJlJlll
1^
60
Ijltlfl
1 1
1
DOO-—
000-—
Mixer, etc.
Monitor speal<ers
(self-powered)
|i®ii'ai-©§f
MIX
OUT
purposes
here)
'i'
1
1
1 1
!==1( )
1 1
Power amp
Stereo set, etc.
Radio-cassette
player
>
About the Output Jacks
These jacks
are for the output of audio signals.
You can connect them to
monitor speakers, a PA system, or
other audio
equipment
(Ordinarily,
you
can connect with MIX
OUT). To get tlie best sound from the
JV-
lOBD,
we recommend that you use
its
output
in stereo. But if you
want monaural output, connect a
cable to
the L (MONO) jack.
10
To Next Page
Loading...
