Roland JV-30 - Page 25

Editing Tones
Q
Filter
#
Cutoff
Frequency
1 Piano 1
Cutoff Fre=i-
: 4-10
Resonance
1 Piano
1
Resonance:
+20
The following settings affect the nuance of
a
sound
by
applying changes to its har-
monic structure.
Sets
the frequency at
which the harmonic content
will
be cut. Range:
'-50
to
+16.
The lower the
value, the more "pleasant" the
sound becomes.
Provides an
adjustment for the amount
of emphasis that is
to be
placed on the har-
monic content in the
vicinity of the Cutoff Frequency.
Range:
-50
to
+50. The higher the value, the more
distinctive the sound becomes.
Q
Envelope
A
Attack
Time
1 Piano 1
Attack Tine:
+
10
Decay
Time
i
Piano 1
Decay
Tir-ies
+
10
Release
Time
1
Piano,
1
Re
1 e.Eise T i
p'le
:+10
The
following settings adjust
the volume and the
change that occurs over
time in the
Cutoff Frequency.
Adjusts
the time it takes
for the initial portion
of
a
sound to be heard
after
a
key is
pressed.
Range:
-50
to
+50. The
higher'the value, the
slower the attack becomes.
Adjusts
the time it takes
before the
"Sustain Level" for the
sound is reached, after
the
Attack has
finished.
Range:
-50
to
+50. The higher the
value, the
longer the time becomes.
I
Sustain Level:
The level at
which
volume/cutofffrequency
changes stabilize.
Adjusts the
time it takes before
the sound will fade away
after
a
key is released.
Range:
-50
to +50. The
higher the value, the
longer the time becomes.
Storing Edited
Tones
The
"Write Procedure"
must
be
performed
in order to
retain the changes you
make to a Tone.
The
destination for an edited
sound is
a
User
Tone located at
the same
Bank/Number
as
the
cur-
rently selected Tone.
'
BANK
DJ
+
NUMBER |T]
+ I
VARIATION
: BANK
IT]
+
NUMBER
[5]USER
-
I
USER
I
: BANKrn+
NUMBERlTI
Write
Procedure
[Write
Procedure]
+
While
holding this
dow/n,...
Hold
down [WRITE] and
press the
NUMBER [l]-[8]
button that is
blink-
ing, to
write the edited
Tone into
memory.
If you
let
up
on the
[WRITE] before
pressing a
NUMBER
11)-[8),
then
nothing
happens and the
Write
Procedure is
canceled.
*
User Tones do
not have any
Variations. If
you create a
sound that
is an
edited version
of a
Variation, you
need to write it to
the
Number button
where that
Variation
belongs.
*
Care
should be taken
when performing
the Write
Procedure,
since any
Tone that
was
previously
stored at the
destination will be
overwritten
(erased).
25