Roland JX-08 - Reverse Dly; T-Scream

Effect Parameters
51
You can also press a step button to select the parameter items.
Reverse Dly
Step
buttons
Parameter Value Explanation
[1]
tyPe R.dLy
This is a reverse delay that adds a reversed and delayed sound to the
input sound. A tap delay is connected immediately after the reverse
delay.
[2]
Sľ
Off
,
On
Turns the effects on/off.
[3]
Sync
Off
,
On
When this is ON, the effect synchronizes with the tempo of the
rhythm.
“8.2.1. Tempo Settings(P.28)”
[4]
TiNE
1
–
2600
(ms)
Adjusts the delay time from the direct sound until the delay sound is
heard.
[5]
notE
“12.1.18. About note
values(P.57)”
[6]
Fb
-
98
–
98
(%)
Adjusts the proportion of the delay sound that is fed back into the
effect. (Negative values invert the phase.)
[7]
bAL
Volume balance between the effect sound and dry (original) sound
0
Effect sound : Dry sound = 0 : 100
100
Effect sound : Dry sound = 100 : 0
[8]
EQ.Lo
-15
–
15
(dB)
Amount of low range boost/cut
[9]
EQ.Hi
-15
–
15 (dB)
Amount of high range boost/cut
[10]
LEU
0
–
127
Output level
You can also press a step button to select the parameter items.
T-Scream
Step
buttons
Parameter Value Explanation
[1]
tyPe Od
This models the analog overdrive of the past. It adds a nice amount of overtones
without dirtying the sound.
[2]
Sľ
Off,
On
Turns the effects on/off.
[3]
diSt
0
–
127
Adjusts the amount of distortion.