Manual Version 3.21
Page. 16 of 73
2) Mode
This sets how the delayed sounds are output sequentially. As you rotate the α Dial, the Display changes as follows:
“U – L - U“ / “U – L - L“ / “U - L”
• Key Mode Select: Whole (Upper, Lower), Dual and Split
• Tone Number: Tone(s) in a Patch Memory
• Chase Play: When the Key Mode is Dual, delay-like effect can be obtained
******: U-L-U-
U-L-L-
U-L
Three Modes
3) Time
This sets the time between the first (Upper) sound and the second (Lower) sound.
Press the TIME Chase Play Button to select Time Adjust mode, then change the value using the α Dial. Choose a
value from 01 to 99. The higher number represents a longer time.
**: 01 to 99
When you have completed editing all the functions, press the ENTER Key.
*If the level described on the previous page in “1) Level” is set high and the key aftertouch is set to a high value,
more delay sound from the “Lower” sound can be obtained. If the Tone Parameter Number 63 “VCA Dynamics
Range” is set to OFF, the volume of the sound does not change, but repeats at the same volume.
52 chase play mode
******
52 chase play time
**
To Next Page
Loading...
