Roland JX-10 - Chase Play

Manual Version 3.21
Page. 19 of 73
36
Upper lfo mod depth
00 to 99
These Factors set the depth of the Vibrato effect
obtained with the Bender lever. At 00, no effect is
obtained. Increasing the value deepens the effect.
46
lower lfo mod depth
00 to 99
#
Parameter
Range
Description
37
Upper portamento
On off
These Factors turn the Portamento ON or OFF. The
Portamento effect for the Upper and Lower can be
switched ON or OFF separately.
47
Lower portamento
On off
38
Upper BENDER
On off
These Factors turn the Bender ON or OFF. The
Bender effect for the Upper and Lower can be switched
ON or OFF separately.
48
Lower BENDER
On off
CHASE PLAY
#
Parameter
Range
Description
51
Chase play level
00 to 99
See pages. 15 - 16
52
Chase play mode
u-l-u-, u-l-l-, u-l
53
Chase play time
01 to 99
The Chase Play function makes it possible to output the Lower sound slightly later than the Upper sound. This
function, however, is available only in Dual Mode. Depending on the delay time and the Tone in use, the effects
created can differ; delay-like effect, sound-on-sound effect etc.
PROCEDURE
1. Press the Chase Play ON / OFF Button. The corresponding indicator will light up, showing that the Chase Play
function is turned on.
2. Set the following 3 functions: Time, Level and Mode so that the desired effect is obtained.
The “Level” and “Mode” are alternately selected by pressing the FUNCTION Chase Play Button.
The Display shows the function selected.
The “Time” function can be selected by pressing the TIME Chase Play Button. The value of the selected function
can be changed by using the α Dial.
#
Parameter
Values - Range
Notes
51
Chase play level
00 to 99
This sets the level of the delayed sound (= Lower
sound).
Rotate the α Dial, to set the required value. The
value can be set from 00 to 99. The higher number
sets a higher level.
52
Chase play mode
U-L - U-L-L - U-L-U
This sets how the delayed sounds are output
sequentially. As you rotate the α Dial, the Display
changes as follows: "U-L-U", "U-L-L" or "U-L".
• U-L-U: In this mode, Upper sound is output
first, then Lower, Upper, Lower repeatedly.
• U-L-L: In this mode, Upper sound is output
first, then Lower sounds repeatedly.
• U-L: In this mode, Upper sound is first output
then Lower. No more sound is output.
53
Chase play time
01 to 99
This sets the time between the first (Upper) sound
and the second (Lower) sound.
Press the TIME Chase Play Button to select Time
Adjust mode, then change the value using the α
Dial. Choose a value from 01 to 99. The higher
number represents a longer time.
When you have completed editing all functions,
press the ENTER Key.
54
Chase play switch
On off
Same as Chase Play button ON / OFF.