Roland JX-10 - Writing All Edited Data at Once; WRITE Menu Options

Manual Version 3.21
Page. 33 of 73
NOTE: Even when a Patch Memory or Tone is edited but not yet written into memory, executing the NAME
procedure will automatically write the edited Patch Memory or Tone into memory erasing the original data written in
memory!
4.9d Writing the whole data
Instead of separately writing each element of edited data (such as Patch Memory, Tone, Name or Quick Edit data),
the whole edited data can be written into memory all at once.
PROCEDURE
1. When you have finished all the necessary edits, press the EDIT Button
The Display will return to its normal indication, showing the relevant data has been edited.
2. Press the WRITE Button
3. Press the ENTER Key.
The whole chunk of edited data has now been written into memory and the Display will return to its normal
indication.
WRITE MENU
The following displays will show up just by pressing the WRITE button and rotating the α Dial until the desired
operation to be accomplished is found. To complete a WRITE operation, you must always press the ENTER
button. Pressing WRITE again (without pressing ENTER first), will cancel the operation.
Display
Note
Press ENTER - the corresponding Patch, Upper and Lower Tones will
be saved (i.e. overwritten) into their respective memory locations.
Press ENTER - the corresponding Patch will be saved into memory
(i.e. overwritten). Otherwise, select with A–H, 0–9 to write to another
memory location.
Press ENTER - the corresponding Upper Tone will be saved into
memory (i.e. overwritten). Otherwise, select with 0–9 to write to another
memory location (00 – 49).
Press ENTER - the corresponding Lower Tone will be saved into
memory (i.e. overwritten). Otherwise, select with 0 – 9 to write to
another memory location (00 – 49).
Press ENTER - MIDI settings will be saved. Refers to ALL settings in
the MIDI menu (MIDI 11 → 42).
WRITE VOICE
WRITE PATCH
WRITE UPPER
WRITE LOWER
WRITE MIDI SETTINGS ?