Roland JX-10 - Control Channel

Manual Version 3.21
Page. 43 of 73
• System Exclusive
This message is not affected by channel setting. Call it by assigning its Function Number 21, then turn it ON or OFF with the α Dial
• To assign the Function Number of a MIDI message, the α Dial can be used instead of the Ten Keys. After
pressing the MIDI then PARAM buttons, rotate the α Dial and the Function shown in the Display will change in
sequence. When the Function you wish to edit appears in the Display, press the VALUE Edit button, then
change value with the α Dial. However, to continue to edit other Functions, be sure to press the PARAM
button, then call the Function you want by using the α Dial.
• To cancel MIDI function edit mode, simply press the MIDI Edit button.
b. MIDI Functions available for a Patch Memory
The MIDI Functions shown in the following table can be written into memory as Factors of a Patch memory. You
may, however, want the JX-10 to send the MIDI messages to the receiver without being affected by the Patch
Memory’s MIDI setting. If so, you can turn the relevant MIDI Functions in a Patch Memory off. The necessary
procedure is exactly the same as when editing a Patch Memory. Note that these MIDI functions are only available
from within the Patch Edit section – not via the MIDI edit function.
#
Parameter
Range
Description
61
Up midi ch send
1 to 16 off
These Factors can select 1-16 number or OFF for the
Upper and Lower separately.
62
LO midi ch send
63
Up prog change send
1 to 128 off
These Factors can select 1-128 Program Change or
OFF separately for the Upper and the Lower sections.
64
Lo prog change send
65
Up volume send
00 to 99 off
These Factors are used for transmitting the Volume
messages in the Control Change separately on the
MIDI Channels selected by the Upper and the Lower.
66
Lo volume send
67
Midi SEND key mode
Upper
Lower
Split
Layer
off
This Factor can select Upper, Lower, Split, Layer or Off
independently of the Key Mode set on the JX-1 0. The
Upper mode sends the JX-10's keyboard information
on the MIDI channel selected at the Upper. Likewise,
the Lower mode sends it on the channel of the Lower.
The Split mode sends it separately on the Upper and
Lower at the Split Point set with Number 68. The Layer
mode sends the
entire information on the both
channels of
the Upper and Lower. At OFF, no
information is sent with MIDI, therefore it is sent with
the set Key Mode on the JX-10.
68
MIDI SEND Split
E1 to g7
When SPLIT is selected at Number 67, this Factor 68
serves to set the Split Point. Set it with the Octave
number and Note name from E1 to G7.
Although MIDI instructions in Section 7 remain valid and still apply, with firmware ver. 3.0+ the MIDI menu
has been improved. Note that MIDI Parameter Numbers have changed compared to the original JX-10!
MIDI MENU
MIDI Factors can be recalled through the ten keys (numeric keypad) or pressing PARAMETER button and rotating
the α Dial until the desired Factor is found. Pressing VALUE button and rotating the α Dial will edit the current
value.
Display
Values
Note
ON - OFF
ON = Upper part of the keyboard is active*
OFF = Upper part of the keyboard is muted* and
can transmit MIDI data to an external instrument
*According to Upper split point
ON - OFF
ON = Lower part of the keyboard is active*
OFF = Lower part of the keyboard is muted* and
can transmit MIDI data to an external instrument
*According to Lower split point
1 - 16
MIDI control channel freely selectable among 1-16
11 UPPER LOCAL
12 LOWER LOCAL
15 CONTROL CHANNEL