Roland JX-305 GrooveSynth - Factory Preset

JX-305 Sep. 1998
8
FACTORY PRESET
1. Press [UTILITY].
The indicator will light.
2. Press PAGE [<] [>] several times to select "FACTORY
PRESET", and press [ENTER].
The Factory Preset page will appear.
3. Press PAGE [<] [>] several times to select "ALL".
4. Press [ENTER].
The following display will appear.
5. Press [ENTER].
The following display will appear, and the factory data
will load.
NOTE: It take about 1 minute to complete the data loading.
Never turn the power off while this procedure.
6. When Factory Preset ends, the following display will
appear, and the system will reboot automatically.
Upgrading the program memory
software version
JX-305 uses the FLASH MEMORY.
These ROMs can be update the program by transferring the
data in the upgrading disk (SMF format), through MIDI.
Required Items
⋅
JX-305 Version Up Disk Set (PNo. 17048906)
(The Version up disk contains the JX-305 program
converted into SMF data. Obtain the latest version from
the service center.)
⋅
Sequencer (Anything that will play back SMF will do.)
⋅
MIDI cable
Update procedure
1. Connect MIDI OUT of the Sequncer with MIDI IN of the
JX-305.
2. Turn the power on while holding down [MUTE CTRL]
button, hold on to press [MUTE CTRL], press the
[NUMBER 3 (HH)] button.
Display Shows as follows
3. Press the [ENTER] button, then JX-305 check the ROM-
ID number.
And display shows as follows.
Check to see that the display shows as described above
and then playback the SMF data. When the update
procedure is in normal operation, BEAT LED will blink.
The file names are as follows.
_000001.mid
_000002.mid
|
_000016.mid