Roland KC-600 - Plain View (Fig.B); Disassembly Procedure; Important Notes When Bundling the Wiring

15
Jan. 2018 KC-600
Plain View (Fig.B)
fig.heimenzu-B-KC-400-600.eps
Disassembly Procedure
Detaching the Chassis Assy
1. Remove screws f (x 3) in View 5 at Plain View (p. 8).
2. Remove screws f (x 3) in View 3 and screws f (x 3) in View 4 at Plain View
(p. 8).
3. Slide the Chassis Assy a short distance toward the rear side and
disconnect wirings (x 3).
4. Pull out the Chassis Assy slowly.
Detaching the Speaker
1. Remove screws a (x 8) in View 1 at Plain View (p. 8) and detach the Grill
Assy.
2. Remove screws c (x 4) and d (x 8) in View 2 at Plain View (p. 8).
3. Detach the speakers slowly and disconnect wirings connected to the
speakers.
* When connecting the wirings, refer to the following figure.
fig.bunkai-tejun.eps
Important Notes When
Bundling the Wiring
* When bundling the wiring, give attention to the following points.
fig.wire-clamp-e.eps
p
p
q
q
View B
No. Part Code Part Name Description Q’ty
p 40017934 SCREW M3X6 PAN MACHINE W/SW+PW(L) FE ZC 11
q 40013001 SCREW M4X8 PAN MACHINE W/SW+PW BZC 3
Woofer
Orange
Black
Red
Brown
Tweeter
Cross the left and right
wirings and bundle them.
Do not bundle
this wiring.