4.
Check the results of the cutting test and make adjustments.
Open the front cover.
Check the results of the cutting test and make adjustments.
P. 114, "Fine-tuning the Cutting Conditions," p. 116, "Adjusting the Cutting-in Amount"
Close the front cover.
5.
Check the results of the cutting test and make adjustments.
Use to move the cutting carriage.
Align the center of the blade with a location where you can perform a cutting test overtop the
cutting-test print pattern.
Press .
Press .
Open the front cover.
Check the results of the cutting test.
Adjustment is complete when optimal results are obtained. If further adjustment is needed, go
back to step
4.
-
and ne-tune the adjustment.
To Next Page
Loading...
