Roland LEC-330 - Aligning Manually and Cutting

Chapter 5 Feature Reference
5-7 Performing Printing and Cutting Separately
125
Chapter 5 Feature Reference

If this does not resolve the problem, then perform alignment manually.
 P. 125, "Aligning Manually and Cutting"
If the crop marks cannot be detected easily because of the eects of media warping or the like, then
perform alignment manually. When you want to perform automatic alignment with lengthy media, we
recommend performing output with the data separated into sizes that are as short as possible. With
large sizes, error due to warping and the like increases, making smooth detection impossible.
To Quit Detection and Start Cutting

Press .
Crop-mark detection stops. Depending on the content of the
data, some time may pass before detection actually stops.

Press .
This stops detection and starts cutting.
Note: After pressing
in step

, resuming detection or canceling output is also possible.
 P. 90, "Pausing or Canceling Output"
Aligning Manually and Cutting
Depending on the type of media, it may not be possible to detect crop marks automatically. When crop
marks cannot be detected automatically, you perform alignment manually.
1. Set the base point.

Use to align the center of the blade with the loca-
tion shown in the gure.

Press .
CANCEL CROPMARK
DETECTION?