An Error Message Appears
7
FAQ
184
[PINCHROLL ERROR INVALID RIGHT (LEFT) POS]
The right (or left) pinch roller is positioned at a location where it does not pinch the media.
Flip the loading lever down to the rear, and then move the right (or left) pinch roller to the correct location.
P. 36, “Loading Media”
[WRONG CARTRIDGE]
A cartridge that cannot be used was installed.
Remove the cartridge to clear the error. Use a cartridge of the specied type.
[WRONG HEAD IS INSTALLED]
An unusable print head is installed.
Switch o the sub power. After you switch o the power, inform your authorized Roland DG Corp. dealer.
[AVOIDING DRY-UP TURN POWER OFF]
The print heads were forced to standby position to prevent them from drying out.
Operation cannot be continued. Switch the sub power o, then back on. Opening the front cover while printing
is in progress causes an emergency stop. Never allow the print heads to remain in this state.
[MOTOR ERROR TURN POWER OFF]
A motor error occurred.
Operation cannot be continued. Switch o the sub power. Next, eliminate the cause of the error, then im-
mediately switch on the sub power. If the machine is allowed to stand with the error uncorrected, the print
heads may dry out and become damaged. This error may be caused by such factors as a mistake in loading
the media, a media jam, or an operation that pulls the media with excessive force.
The media has jammed.
Carefully remove the jammed media. The print heads may also be damaged. Perform head cleaning, then
perform a printing test and check the results.
The media was pulled with excessive force.
Excessive tension was applied to the media, and additional action is necessary to recover from this state.
First, move the loading lever to the rear and adjust the media to create a small amount of slack, then switch
on the sub power.
[CANCELED FOR MOTOR PROTECTION]
Continuous operation made the pump motor become hot, and so operation was paused.
Press any key to clear the error. Allow the machine to stand for approximately 40 minutes before resuming
operation.
To Next Page
Loading...
