2
Basic
Operation
Setup of Media
60
[Two shapes are peeled off separately]
Press
to select [DONE].
Press
to enable the setting.
Go to Procedure
7
.
[Two shapes are peeled off together/backing paper is
also cut]
Press
to select [YES].
Press
to enable the setting.
Go to Procedure
.
Press to adjust the blade force.
If two shapes are peeled o together raise the blade force.
If backing paper is cut too reduce the blade force.
Press to enable the setting.
Cut the test pattern again. Check the result.
[Two shapes are peeled off separately]
Press
to select [DONE].
Press
to enable the setting.
Go to Procedure
7
.
[Two shapes are peeled off together]
Press
to select [YES].
Press
to enable the setting.
Cut the test pattern again. Go back to the procedure
and set
again.
For the individual setting method of this setting item and the description, refer to page 134 "Fine-tuning the
Cutting Conditions."
7.
Correcting Misalignment for Printing and Cutting
Press to select [SET].
Press
to enable the setting.
The test pattern (P&C1) is printed and cut. The test pattern is printed
at three locations on the media: at the two edges and in the center.
CONTINUE ADJ. ?
[YES] DONE
CUT FORCE
50gf 50gf
REDO ADJ. ?
YES [DONE]
Subtle misalignment between the printing and cutting positions may occur due to the thickness of
the media or the head height. We recommend making correction to match the media you're using.
PRINT-CUT ADJ.
[SET] NEXT
Current correction
value
Value to be set
To Next Page
Loading...
