2
Basic
Operation
Setup of Media
61
Check the test pattern condition.
[Cutting position and printing position are aligned]
Press
to select [DONE].
Press
to enable the setting.
Go to Procedure
8
.
[Cutting position and printing position are not aligned]
Press
to select [YES].
Press
to enable the setting.
The test pattern (P&C2) for setting the correction values is printed
and cut. Go to Procedure
.
When the left gure is displayed, press .
Continued on the next page
To check the test pattern (P&C1)
Check to make sure that the printing position and the cutting position are aligned.
CONTINUE ADJ. ?
[YES] DONE
INPUT
ADJ. VALUES
Cutting position and printing posi-
tion are misaligned.
Cutting position and printing posi-
tion are aligned.
Cutting position
Printing position
To Next Page
Loading...
