Roland M-160 - Channel Section Panel Description

[2] PANEL DESCRIPTION
1. Channel Section
PEAK PEAK
Osicwat O signal
SENS SENS
-25 -25
Ny ’ ‘ ’
= -50 -10 «-50
@ Peak/Signal Indicator
When signals higher than ~24dB (rated level) are input, the
indicator
lights
up
green,
which
means
the
input
signals
are
sufficient level. When signals reach the clipping level (--6dB),
the indicator lights in red.
@ Sens Knob
This
knob
adjust
the
sensitivity
of
the
input
signal.
Set
this
so
that
the
Peak/Signal
Indicator
will
light
green
and
occasionally
red.
If
the
Peak/Signal
Indicator
does
not
light
up
at
all,
rotate
the
Sens
Knob
clockwise
or
increase
the
level
of
the
input
signal.
*
Channels
1
and
2
have
rated
inputs
of
—50
to
—10dBm
which
are
appropriate
input
sensitivities
for
micraphane
level,
while
Channels
3
to
16
have
—20dBm
to
+4dBm
rated
input
appropriate
for
line
level.
©. @ and @ Effect Volume Knobs
These
adjust
the
level
of
the
signals
to
be
sent
to
Effect
Sends.
* The position where the signals are sent to the Effect Send
is Post Fader (after passing the Channe! Fader).
@ AUX Volume Knob
This adjusts the level of the signal to be sent to the AUX Send.
This, therefore, can be used for monitor sending, recording
output or effect sending.
* The position where the signals are sent to the AUX Send
can be selected at the Master Section; Pre or Post.
@ Panpot
This sets the placing of the sound imaging in stereo sound
field. At the center position, the volumes of L and R are equal.
© Channel Fader
This sets the level of the signa! to be sent out from a Channel.
* Before switching on or off the mixer, be sure to set the
Master Fader to zero.
* For about 3 seconds, muting circuits work, therefore, no
sound is output.