Roland M-160 - Master Section Panel Description

2. Master Section
MASTER
LINE
a Roland mea
Mele)
RETURN SEND
RIN 1 EFFI
1B, a
©; | O:
AIN 2 EFF 2
vB, a,
©: °° 10
RIN 3. EFF 3
®;: Qo 10
RIN 4 ALIX
. > ’ . ] ,
©: | 0;
RTN 4 PAN
.o, AUX SELECT
Low wR m PRE
POWER
@—-Co -—o
@ Peak Meters
Use these peak-indicating level meters to observe the ouptut
leveis from the Master Out's. When “OdB” Sights up, the level
from the Master Out is +4dBm.
@ Pre-fader Signal Indicators
These can be used to observe the output levels of the ampli-
fiers where signals from Channels are mixed. The position
where the signals are read is Pre Master Fader (before the
Master Fader). When it is equal to the rated level —20cdB, the
indicator lights in green, and when it is clipping level —6dB, it
lights in red.
© Master Faders
These adjust the final sending levels of the mixed signals.
@. &. © and @ Return Volume Knobs
These adjust the levels of the signals sent to the Return Jacks.
@© Panpot
This sets the sound imaging of the Return 4. At the center
position, the volumes of L and R are the same.
©. © and @ Effect Send Volume Knobs
These adjust the levels of the signals to be sent to the effect
units.
@ AUX Send Volume Knob
This adjusts the final sending level of the signal mixed at the
AUX Volume of each Channel
@® AUX Selector Switch
This selects the position where the signals are sent to the
AUX Send. When PRE is selected, the signals are taken before
the Channel Fader, therefore, the mixer can be used as a
monitor. When POST is selected, the signals are taken after
the Channel Fader, therefore the mixer can be used as an effect
send,
@ Headphone Volume Knob
This adjusts the volume of the headphone signals which are
the mixture of the signals from each Channel Fader and the
Phones Mix In.
* The signals are sent out before going to the Master Fader,
therefore the headphones can be used for monitoring
@® Headphone Jack
Connect stereo headphones to this jack.
@ Power Indicator
This lights up when the mixer is switched on
@ Power Switch
Pushing this switch turns the mixer on, and pushing it again
turns off.
* Before turning on or off the mixer, be sure to set the Master
Faders to zero.
* For about 3 seconds after the mixer is turned on, muting
circus work, therefore no sound is output.