Roland M-160 - Rear Panel Connections Overview

3. Rear Panel
Mm
=.
OO9O
() CAUTION
RISA OF ELECTRIC SHOCK
‘DO NNT OOF
WARNING
dy AME AYSk
oF
* 00 NO? EXPOSE
PPL THiS a
ATTENTION. arsove vt croc FLECTRIGUE WE FAS QUVRIR| | HAIN OM MOISTURE
@ input Jacks
Channels 1 and 2 are for connecting microphones, musical
instruments, etc. Channels 3 to 16 are for devices with line
level and musical instruments.
@ Level Switch
This selects the input fevel for the Returns 1 and 2 depending
on the connected unit.
© Return Jacks
These are to feed the signals returned from the effect units.
These can also be used as AUX input jacks. Returns 1 to 3 are
for stereo input, and Return 4 is for monaural only. Returns 1 to
3 can also be used as monaural inputs if L sides are connected.
@ Phones Mix In Jack
This is to feed the Monitor Mix signal, sequencer click sound,
etc. The input signals are sent to the Headphone Jack only.
* The signals fed through this jack are not sent to the Master
Out
© Effect Send Jacks
These are to send the signals to the effect units
@ AUX Send Jack
This sends out the signals lo a monitor or effect unit.
@ Bus In Jacks
Signals fed through these jacks can be directly mixed with
the Effect Send and AUX Send Busses. When two mixers are
stacked, connect the Effect Send of one mixer to the Bus In
Jack of the other one, and effects on two mixers can be con-
trolled by one mixer.
* The signals fed through these jacks are not sent to the Mas-
ter Out (L, R)
© Master Out Jacks
These are to connect to a power aimplifier, etc.
© Master Out Connectors
These are XLR (balanced) type connectors for connecting a
power amplifier, etc. The standard jacks @ and the XLR con-
nectors @ can be used simultancously.
* The XLR Connectors of this unit are standardized to 1st pin-
Ground, 2nd pin-Cold and 3rd-Hot. When cannecting to the
other unit, check the type of the connectors.