Roland M-160 - Connections and Operation Guide; Basic Connection of Microphones and Instruments; Mixing Microphones and Musical Instruments

[3] CONNECTIONS AND OPERATION
= Basic Procedure
@ Make sure that the mixer is turned off, then connect the
power cable to the socket.
@ Connect all the relevant devices to the mixer. (See the pic-
ture shown below.)
@) Set all the control knobs and faders to zero.
@ Check if all the connections have been correctly made.
Turn the pre-stage devices on, then the mixer, then the
power amplifier. When switching off the devices, take
the reverse procedure
1. Basic Connection of microphones and musical
instruments
Keyboard
Ap
HP-5600,
D-50
|
eee
sud
$-50, Super-JX etc.
Rolanc
maa Re was
aru MIE
O6|6 616 6 <
por Ct
PO oe Mee Cy cin Ameren v0
Caan rT
00 as ote Ps O O 0 Oj! Oo
e. Naar
one) (exe
WARNING
rN 20 mec nt arte
fe time on Lurene
See te Sa ats
¢
ATTENTION mvone oF conc LECH Out nt ras ouveemt | Bam OR BONTURE
la é ge wos PRE
| GIG ]O G)O GJOjO
OUT OUT
1N IN
Power Amplifier
SRA-1200
SRA-2400
SRA-4800 etc.
= Mixing of microphones and musical instruments
@ As you play the instrument, set the Sens Knob so that the
Peak/Signal Indicator will occasionally lihgt red.
@ Set the Channel Fader around 7, then adjust the overall
volume with the Master Fader.
* {f the Pre-fader Signal Indicator lights in red too often, lower
the Channel Fader.
Speaker
SST-80, 120 |
SRS-80, 120 etc.
® Set the sound imaging of L and R with the Panpot.
@® Adjust the volume balance of each Channel with the Chan-
nel Fader.