Roland M-200i V-mixer - Recording to USB Memory

79
USB memory recorder
USB memory recorder
By default, the inputs of the USB memory recorder are specified
as follows:
You use the REC SOURCE SELECT screen to specify the inputs.
1.
Access the RECORDER FUNCTION screen.
2.
Select “REC L SOURCE SELECT“ and press [ENTER].
The REC L SOURCE SELECT screen is displayed.
3.
Move the cursor to the channel that you want to make
the input source and press [ENTER].
4.
Make the setting in the same way for R as well.
By default, the outputs of the USB memory recorder are specified
as follows:
You use the PLAY DESTINATION SELECT screen to specify the
output destinations.
1.
Access the RECORDER FUNCTION screen.
2.
Select “PLAY L DESTINATION SELECT“ and press [ENTER].
The PLAY L DESTINATION SELECT screen is displayed.
3.
Move the cursor to the Moving the cursor to that you
want to make the output destination and press [ENTER]
to attach a check mark to it.
4.
Press [EXIT] to quit the screen.
5.
Make the setting in the same way for R as well.
You can select more than one channel as the output
destination.
1.
Access the RECORDER screen.
2.
Press [ ].
The USB memory recorder goes into recording standby.
3.
Press [ENTER].
Recording to the USB memory starts.
You can split the WAV file by pressing [ ] during recording.
4.
To stop recording, again press [ENTER].
USB memory recorder input-source
settings
Input
Input source
REC L MAIN L
REC R MAIN R
USB memory recorder output-
destination settings
Output
Output destination
PLAY L CH31
PLAY R CH32
Recording to USB memory
M-200i_e.book 79 ページ ２０１３年１月１６日 水曜日 午後４時９分