Roland M-400 - Page 12, About Cables; Types of Ethernet Cable; Crossover Cable; Straight Cable

12
Command details
PGC: Preamp gain setting
Function Sets the pad and preamp gain of a channel.
Syntax stxPGC:a,b,c; (Command syntax: type 2)
a: Channel selection (I1–I48, U1–U24)
b: Pad on/off
0 (Off)
1 (On)
c: Preamp gain *1 dB steps
-10 to -65 (with pad off)
10 to -45 (with pad on)
0 to -18 (for STEREO IN channel)
<Ex.> stxPGC:I1,1,4;
Turns the CH1 pad on, and sets the preamp gain to +4 dB.
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify a channel that has no gain adjustment
• If you turn on the pad of a channel that has no pad
• If you specify a GAIN of 10 to -9 for a channel whose pad is turned off
• If you specify a GAIN of -46 to -65 for a channel whose pad is turned on
• If you specify a GAIN setting outside the range of 0 to -18 for the STEREO IN channel
• If you specify U1–U24 that is assigned to the above
FLC: Filter on/off
Function Turns the filter on/off.
Syntax stxFLC:a,b; (Command syntax: type 2)
a: Channel selection (I1–I48, U1–U24)
b: On/off
0 (Off)
1 (On)
<Ex.> stxFLC:I1,1;
Turns the CH1 filter on.
Note: If you’re selecting a stereo-linked input channel, you can set this for either the L or R channel (not both).
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify AX1–AX16, MAL, MAR or DCA1–DCA8
• If you specify U1–U24 that is assigned to the above