Roland M-400 - EQC: EQ On;Off; GTC: Gate On;Off

13
Command details
EQC: EQ on/off
Function Turns the four-band EQ on/off.
Syntax stxEQC:a,b; (Command syntax: type 2)
a: Channel selection (I1–I48, AX1–AX16, MAL, MAR or U1–U24)
b: On/off
0 (Off)
1 (On)
<Ex.> stxEQC:I1,1;
Turns the CH1 four-band EQ on.
Note: If you’re selecting the MAIN channel, you’ll be able to set this only for L or R (not both), since the MAIN L/R
channels are stereo-linked.
Note: If you’re selecting a stereo-linked input channel or AUX channel, you can set this for either the L or R channel (not
both).
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify DCA1–DCA8
• If you specify a U1–U24 that is assigned to the above
GTC: Gate on/off
Function Turns the gate on/off.
Syntax stxGTC:a,b; (Command syntax: type 2)
a: Channel selection (I1–I24)
b: On/off
0 (Off)
1 (On)
<Ex.> stxGTC:I1,1;
Turns the CH1 gate on.
Note: If you’re selecting a stereo-linked input channel, you can set this for either the L or R channel (not both).
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify I25–I48, AX1–AX16, MAL, MAR or DCA1–DCA8
• If you specify U1–U24 that is assigned to the above