14
Command details
CPC: Comp/limiter on/off
Function Turns the compressor/limiter on/off.
Syntax stxCPC:a,b; (Command syntax: type 2)
a: Channel selection (I1–I24, AX1–AX16, MAL, MAR or U1–U24)
b: On/off
0 (Off)
1 (On)
<Ex.> stxCPC:I1,1;
Turns the CH1 compressor on.
Note: If you’re selecting the MAIN channel, you can set this for either L or R (not both), since the MAIN L/R channels are
stereo-linked.
Note: If you’re selecting a stereo-linked input channel or AUX channel, you can set this for either the L or R channel (not
both).
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify I25–I48 or DCA1–DCA8
• If you specify U1–U24 that is assigned to the above
AXC: AUX send setting
Function Sets the AUX send level and AUX pan from CH1–48 or MAIN.
Syntax stxAXC:a,b,c,d; (Command syntax: type 2)
a: Channel selection (I1–I48, MAL, MAR or U1–U24)
b: AUX channel selection (AX1–AX16)
c: AUX send level (INF, -80.0–10.0) *0.1 dB steps
d: AUX pan (L63–C–R63) *Steps of 1
<Ex.> stxAXC:I1,AX15,4.0,R30;
Sets the CH1 AUX15 send level to +4.0 dBu, and the AUX pan to R30.
Note: If you’re selecting an AUX channel, and specify an AUX channel that is not stereo-linked, the M-400 will ignore the
AUX pan parameter.
Note: If you’re selecting the MAIN channel, you can set the AUX send level for either L or R (not both), since the MAIN
L/R channels are stereo-linked. AUX pan can be set individually for L and R.
Note: If you’re selecting a stereo-linked input channel, the AUX send level can be set for either the L or R channel (not both).
AUX pan can be set individually for L and R.
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify AX1–AX16 or DCA1–DCA8
• If you specify U1–U24 that is assigned to the above
To Next Page
Loading...
