15
Command details
PNC: PAN setting
Function Sets the pan.
Syntax stxPNC:a,b; (Command syntax: type 2)
a: Channel selection (I1–I48, AX1–AX16, MAL, MAR or U1–U24)
b: Pan (L63–C–R63) *Steps of 1
<Ex.> stxPNC:I1,L45;
Sets the CH1 pan to L45.
Note: If you’re selecting the MAIN channel, this parameter will operate as Balance since the MAIN L/R channels are stereo-
linked; you’ll be able to set this for either L or R (not both).
Note: If you’re selecting a stereo-linked AUX channel, this will operate as balance, and can be set for either the L or R
channel (not both).
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify AX1–AX16 that is not stereo-linked
• If you specify DCA1–DCA8
• If you specify U1–U24 that is assigned to the above
MUC: Mute on/off
Function Switches mute on/off.
Syntax stxMUC:a,b; (Command syntax: type 2)
a: Channel selection (I1–I48, AX1–AX16, MAL, MAR, DCA1–DCA8 or U1–U24)
b: On/off
0 (Off)
1 (On)
<Ex.> stxMUC:I1,1;
Turns mute on for CH1.
Note: If you’re selecting the MAIN channel, you’ll be able to set this for either L or R (not both), since the MAIN L/R
channels are stereo-linked.
Note: If you select a stereo-linked input channel or AUX channel, you’ll be able to set this for either L or R (not both).
FDC: Fader level
Function Sets the fader level.
Syntax stxFDC:a,b; (Command syntax: type 2)
a: Channel selection (I1–I48, AX1–AX16, MAL, MAR, DCA1–DCA8 or U1–U24)
b: Fader level (INF, -80.0–10.0) *0.1 dB steps
<Ex.> stxFDC:I1,INF;
Sets the CH1 fader to -Inf.
Note: If you’re selecting the MAIN channel, you’ll be able to set this for either L or R (not both), since the MAIN L/R
channels are stereo-linked.
Note: If you select a stereo-linked input channel or AUX channel, you’ll be able to set this for either the L or R channel (not
both).
To Next Page
Loading...
