Roland M-400 - Request Commands; CNQ: Channel Name Request; PTQ: Phantom Power Supply Request

17
Command details
CNQ: Channel name request
Function Requests the channel/group name.
Syntax stxCNQ:a; (Command syntax: type 2)
a: Channel selection (I1–I48, AX1–AX16, MAL, MAR, DCA1–DCA8 or U1–U24)
<Ex.> stxCNQ:I1;
Requests the channel name of CH1.
Command returned by the M-400
Syntax stxCNS:a,“b”; (Command syntax: type 2)
a: Channel number (I1–I48, AX1–AX16, MAL, MAR, DCA1–DCA8 or U1–U24)
b: Channel name (fixed at six characters)
<Ex.> stxCNS:I1,”A.BASS”;
Output the channel name A.BASS for CH1.
Note: If the channel name is blank, the output will be six spaces.
PTQ: Phantom power supply request
Function Requests the on/off status of the +48V phantom power supply.
Syntax stxPTQ:a; (Command syntax: type 2)
a: Channel selection (I1–I48, U1–U24)
<Ex.> stxPTQ:I1;
Requests the on/off status of the +48V phantom power supply for CH1.
Command returned by the M-400
Syntax stxPTS:a,b; (Command syntax: type 2)
a: Channel number (I1–I48, U1–U24)
b: On/off
0 (Off)
1 (On)
<Ex.> stxPTS:I1,0;
Reports that the CH1 phantom power is off.
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify a channel that does not have phantom power
• If you specify U1–U24 that is assigned to the above
Request commands