Roland M-400 - GTQ: Gate Request; CPQ: Comp;Limiter Request

20
Command details
GTQ: Gate request
Function Requests the gate on/off setting.
Syntax stxGTQ:a; (Command syntax: type 2)
a: Channel selection (I1–I24, U1–U24)
<Ex.> stxGTQ:I1;
Requests the gate on/off setting of CH1.
Command returned by the M-400
Syntax stxGTS:a,b; (Command syntax: type 2)
a: Channel number (I1–I24, U1–U24)
b: On/off
0 (Off)
1 (On)
<Ex.> stxGTS:I1,0;
Reports that the CH1 gate is off.
Note: If you specify a stereo-linked input channel, the same value will be returned for L or R.
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify I5–I48, AX1–AX16, MAL, MAR or DCA1–DCA8
• If you specify U1–U24 that is assigned to the above
CPQ: Comp/limiter request
Function Requests the compressor/limiter on/off setting.
Syntax stxCPQ:a; (Command syntax: type 2)
a: Channel selection (I1–I24, AX1–AX16, MAL, MAR or U1–U24)
<Ex.> stxCPQ:I1;
Requests the compressor on/off setting for CH1.
Command returned by the M-400
Syntax stxCPS : a , b ; (Command syntax: type 2)
a: Channel number (I1–I24, AX1–AX16, MAL, MAR or U1–U24)
b: On/off
0 (Off)
1 (On)
<Ex.> stxCPS:I1,0;
Reports that the CH1 compressor is off.
Note: If you specify the MAIN channel, the same value will be returned for L or R, since the MAIN L/R channels are stereo-
linked.
Note: If you specify a stereo-linked input channel or AUX channel, the same value will be returned for L or R.
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify I25–I48
• If you specify U1–U24 that is assigned to the above