Roland M-400 - PNQ: PAN Request; MUQ: Mute Request

22
Command details
PNQ: PAN request
Function Requests the pan setting.
Syntax stxPNQ:a; (Command syntax: type 2)
a: Channel selection (I1–I48, AX1–AX16, MAL, MAR or U1–U24)
<Ex.> stxPNQ:I1;
Requests the CH1 setting.
Command returned by the M-400
Syntax stxPNS:a,b; (Command syntax: type 2)
a: Channel number (I1–I48, AX1–AX16, MAL, MAR or U1–U24)
b: Pan (L63–C–R63) *Steps of 1
<Ex.> stxPNS: I1,C;
Reports that the pan of CH1 is set at the center.
Note: If you specify MAIN as the channel selection, the same value will be returned for L or R, since the MAIN L/R channels
are stereo-linked and this parameter is operating as Balance.
Note: If you specify a stereo-linked AUX channel as the channel selection, the same value will be returned for L or R, since
this parameter is operating as Balance.
Note: If you specify the following parameters, the M-400 will return an ERR command (stxERR:5;) and will ignore your
command.
• If you specify AX1–AX16 that is not stereo-linked
• If you specify DCA1–DCA8
• If you specify U1–U24 that is assigned to the above
MUQ: Mute request
Function Requests the mute on/off setting.
Syntax stxMUQ:a; (Command syntax: type 2)
a: Channel selection (I1–I48, AX1–AX16, MAL, MAR, DCA1–DCA8 or U1–U24)
<Ex.> stxMUQ:I1;
Requests the CH1 mute on/off setting.
Command returned by the M-400
Syntax stxMUS:a,b; (Command syntax: type 2)
a: Channel number (I1–I48, AX1–AX16, MAL, MAR, DCA1–DCA8 or U1–U24)
b: On/off
0 (Off)
1 (On)
<Ex.> stxMUS:I1,0;
Reports that the CH1 mute is off.
Note: If you specify MAIN, the same value will be returned for L or R, since the MAIN L/R channels are stereo-linked.
Note: If you specify a stereo-linked input channel or AUX channel, the same value will be returned for L or R.