Roland M-400 - Setup Procedure; Connection with the Control Computer

6
Setup
To set up the M-400 and the computer that will control it, proceed as follows.
1
Connect the control computer.
Use a RS-232C cable to connect your computer and the M-400.
Refer to "Connection with the control computer" (p. 6).
2
Power up the computer that will be controlling the M-400.
3
Make settings for the control computer
Perform the communication settings.
Refer to "Settings on the control computer" (p. 7).
4
Make settings on the M-400.
Perform the communication settings.
Refer to "Settings on the M-400" (p. 7).
5
Start operating the M-400.
Control computer —-> M-400 data transmission will begin.
1
Power off the M-400 and the computer.
2
On the rear panel of the M-400, set the RS-232C/MIDI switch to the RS-232C
position.
3
Use an RS-232C cable to connect the RS-232C connector of your computer to
the RS-232C connector located on the back of the M-400.
For details on the cable to use, refer to "Connector and cable" (p. 5).
Setup procedure
Connection with the control computer