Roland M-400 - Settings on the Control Computer; Settings on the M-400

7
Setup
1
Communication settings on the computer
* For details on how to set the communication settings, refer to the owner’s manual of the computer you’re using.
When you power up the M-400, the communication speed will be set to 115200 bps by default.
If you’re using the M-400 via RS-232C, you’ll need to set its communication speed to match the setting of the
computer.
For details on how to set this, refer to the M-400 owner’s manual.
Settings on the control computer
Communication method
Synchronous (asynchronous), full-duplex
Communication speed 4800 / 9600 / 14400 / 31250 / 38400 / 57600 / 115200 bps
You can select this as desired, but it must be the same as the setting
on the M-400.
Parity none
Data length 8 bit
Stop bit 1 bit
Code set ASCII
XonXoff on
Settings on the M-400