12
Added effect types
◆HPF : Cuts unneeded low-band popping, noise, etc.
◆ENHANCER : Adds modulation to the sound, making the sound more prominent
Parameter (name) Setting value Remarks
Q (Q) 0.36 – 16.00
Sharpness of the frequency-characteristic curve at the
central frequency
(Not displayed when LSV, HPF1, HSV, or LPF1 is selected as
filter type)
FREQ (frequency) 20Hz – 20.00kHz Central frequency
GAIN (gain) -15.0 – 15.0dB
Amount of boost/cut
(Not displayed when HPF1, HPF2, LPF1, LPF2, BPF, or NOTCH
is selected)
Parameter (name) Setting value Remarks
HPF (HPF ) OFF, ON HPF on/off
FREQ (HPF frequency) 20Hz – 20.00kHz
Cutoff frequency for unneeded low-band popping, noise,
etc.
SLOPE 6 dB SLOPE -6 dB/oct slope
12dB SLOPE -12db/oct slope
18dB SLOPE -18db/oct slope
Parameter (name) Setting value Remarks
ON (enhancer switch) OFF, ON Enhancer on/off
FREQ (enhancer frequency) 20Hz – 20.00kHz Frequency at which application of the enhancer effect starts
SENS (enhancer sense) 0 – 100 Amount of enhancer effect
MIX (enhancer mix level) 0.0 – 12.0dB Volume level of enhancer sound
To Next Page
Loading...
