4
New functionality for scene memory
2. From the scene list, select the target scene, then press [F4 (PARAM EDIT)].
This accesses the RECALL PARAMETER EDIT popup.
❖FADE
USE FADE button
Selecting the check box enables the fade function.
Fade time
This sets the duration of the fade.
You can set it up to a maximum of 100 seconds.
PAN
Selecting this check box enables the fade function for panning (or balance) as well.
3. Select the check box for the USE FADE button.
4. Set the fade time.
5. Press [F8 (OK)] to apply the changes and close the popup.
Recalling a scene memory for which the fade function is enabled and then again recalling the same scene memory
causes the values registered to the scene memory to be updated instantly.
1
3
2
1
2
3
To Next Page
Loading...
