100
Effects and GEQ
Effects and GEQ
Applicable effect indication
This indicates the effect to which the FX INSERT/SOURCE
SELECT popup applies.
Insert-destination/input-source select buttons
Here you can select the insert-destination channel or the
input-source channel for the effect.
The function buttons have the following operations:
1.
Access the EFFECTS screen, and display the FX1–6 tab.
fig.ScrFXOutSelBtn.eps
2.
Move the cursor to the FX DESTINATION SELECT popup
button L or R of the desired effect, and press [ENTER].
The FX DESTINATION SELECT popup will appear.
fig.ScrFXOutSelGuide.eps
Output channel select buttons
These select the output-destination channel for the effect.
You can select more than one output-destination channel.
Applicable effect indication
This indicates the effect to which the FX DESTINATION
SELECT popup applies.
Current output-destination indication
This indicates the current output-destination channel.
If more than one output-destination channel are exist, the
lowest number channel is shown.
Effects such as reverb and delay are typically used in a send/
return configuration.
Here we will explain the procedure for using FX5 as a send/return
type effect using AUX15 and CH41–42.
Specifying the effect input-source
1.
Access the EFFECTS screen, and display FX1–6 tab.
2.
Move the cursor to the FX INSERT/SOURCE SELECT popup
button L for FX5, and press [ENTER].
The FX INSERT/SOURCE SELECT popup will appear.
3.
Press [F3 (AUX OUT)] to access the AUX OUT tab.
4.
Move the cursor to the AUX15 button, and press [ENTER]
to select it.
ig.ScrFXInSel2.eps
5.
Press [F8 (CLOSE)] to close the popup.
6.
In the same way as you did in steps 1 through 5, select
AUX15 as the input-source for the R side of FX5.
[F1 (CH 1–48 INSERT)]
Displays CH1–48 as the insert-destination
channel select buttons.
[F2 (BUS INSERT)] Displays AUX1–16, MTX1–8, and MAIN L/R/C as
the insert-destination channel select buttons.
[F3 (AUX OUT)] Displays AUX1–16 as the input-source channel
select buttons.
[F6 (SELECT NONE)] Clears the input-source selection.
[F8 (CLOSE)] Closes the popup.
Accessing the FX DESTINATION SELECT
popup
2
3
FX DESTINATION SELECT popup button
21 3
1
Using an effect via send/return
2
3
M-480_e.book 100 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
