Roland M-480 - Help Function and Shortcuts

125
Scene memory
Scene memory
• If you press [F5 (INSERT)], a message will ask you to confirm
the Insert operation.
Press [F8 (INSERT)] to carry out the Insert operation. The
scene you selected in step 3 and all subsequent scene will be
renumbered upward by one, and the scene you copied in
step 2 will be copied to the number you selected in step 3.
Pressing [F7 (CANCEL)] will cancel the operation.
If a scene exists at scene number 299, you won’t be able to use
[F5 (INSERT)] to insert a scene.
You can’t paste to a scene that’s locked.
1.
Access the SCENE LIST EDIT popup.
2.
From the scene list, select the scene that you want to cut,
and press [F3 (CUT)].
A message will ask you to confirm Cut operation.
Press [F8 (CUT)] to carry out the Cut operation. The selected
scene will be cut, and the numbers that follow the selected
scene number will be renumbered downward by one.
Pressing [F7 (CANCEL)] will cancel the operation.
Following step 2, you can use [F4 (PASTE)] or [F5 (INSERT)] to paste
or insert the cut scene to any desired scene number.
1.
Access the SCENE LIST EDIT popup.
2.
From the scene list, select the scene whose contents you
want to erase.
3.
Press [F6 (CLEAR)].
A message will ask you to confirm the Clear operation.
Press [F8 (CLEAR)] to carry out the Clear operation. The
contents of the scene you selected in step 2 will be erased.
Pressing [F7 (CANCEL)] will cancel the operation.
You can’t erase a scene that is locked.
Cutting a scene
Erasing the contents of a scene
The Global Scope function
Global Scope is a function that lets you limit the channels and
parameters that will be recalled; its settings apply to all scenes.
The GLOBAL SCOPE popup is used to make settings for the
Global Scope function.
fig.ScrRecallSafeGuide.eps
fig.ScrRecallSafeGuide2.eps
Parameter recall scope buttons
(CH1–48, RTN 1–6, AUX/MTX/MAIN tab)
These buttons specify the scope of the parameters that will
be recalled for the channels selected by the channel recall
scope buttons.
De-select the parameters that you don’t want to be recalled.
GLOBAL SCOPE popup
21
3
1
M-480_e.book 125 ページ ２０１１年３月２日 水曜日 午前９時２０分