Roland M-480 - Page 145

145
REAC applications and settings
REAC applications and settings
To view information about the devices connected to REAC A and
REAC B, you can use the REAC A tab and REAC B tab of the REAC
CONFIG popup.
1.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
2.
Press [F2 (REAC CONFIG)].
fig.ScrSysReacConf1.eps
The REAC CONFIG popup will appear.
3.
Press [F2 (REAC A)] (or [F3 (REAC B)]) to access the REAC A
tab (or the REAC B tab).
fig.ScrSysReacConfABGuide.eps
The REAC A tab (or the REAC B tab) will appear.
Device list
This area shows the devices connected to REAC A or REAC B.
Some devices, like the REAC split devices, may not be shown in
the list.
Device information
This area shows the name, the number of inputs and outputs
and the following information of the selected device:
This area also shows following information:
• S-4000S
You can view the modules that are installed in SLOT1 -
SLOT10.
• S-4000M
You can view the model name and version number of the
units connected to the S-4000M’s port 1–4.
4.
Note the information for the connected REAC device in
the device list and the device information.
If the S-4000M is connected, the function button [F5 (S-4000M
CONFIG)] will appear (p. 146).
Checking the devices connected to REAC
A and REAC B
Firmware Version
Firmware version
REAC Version REAC version
2
1
1
2
M-480_e.book 145 ページ ２０１１年３月２日 水曜日 午前９時２０分